Specific Job Duties:

• Comply with safety standards, policies and procedures
• Fabricate or alter parts using shears, hammers, punches, snips and drills
• Install support hangers, make duct connection using clips, drives, nuts, bolts, TDC tape, sealer, sheet metal screws, etc. as needed
• Cut in 45 degree entry takeoff holes (round, rectangle or square) using hand or electric snips
• Drill and punch holes in metal for screws, bolts, rivets and install spin-in, peel and stick, or airtight duct taps, connect to branch duct
• Cut holes in block or concrete walls and roofs
• Install manual dampers, supporting hardware, etc., make final connections to equipment
• Trim, file, grind, deburr, buff and smooth surfaces, seams and joints of assembled parts using hand tools and portable power tools
• Fasten seams and joints with bolts, cement, rivets, caulk, clips, etc.
• Install round pipe/spiral duct, flex duct, motorized dampers, fire dampers, splitter dampers, louvers, air handlers and flex duct
• Miter ducts
• Insulate duct or wrap if required
• Repair duct liner if necessary
• Use ladder, scaffolding, or lift to reach installation point
• Operate man lift, personal lift, chain hoist, duct jack
• Responsible to complete AQS in order to continue career development

Other Requirements:

• Valid drivers license and ability to meet Company driver qualification policy

Education and Experience:

• High school or trade school graduate or GED
• Preferred but not required - Universal Refrigerant Card and Gas Fitters Card (Type I and Universal)

We are an equal opportunity employer.
Women, minorities, veterans and individuals with
disabilities are encouraged to apply.